Ricambi per Yamaha

**** PLEASE READ THE INSTRUCTIONS FIRST *****
520 Chain to 530 Chain soft rivet link only,
old rivet heads need to be ground off
with an angle grinder before they can be extracted.

For version with Push In type at the oil pump
Will not fit high top carbs
Top upper cable is 63cm
Top inner cable is 69cm
Splitter is 10cm
Outer Carburettor cable is 14.5cm
Inner Carburettor cable is 18.5cm
Outer Oil Pump cable is 40.5cm
Inner Oil Pump cable is 49.5cm

For Version With Threaded End At the Oil Pump and low carb caps
Top Inner Cable is 85cm
Top Outer Cable is 78cm
Splitter Is 9.5cm
Oil Pump Inner Cable is 48cm
Oil Pump Outer Cable is 32cm
Carburettors Inner Cables are 23.5cm
Carburettors Outer Cables are 18cm

Universal fitting clamps onto carburettor, no need for an air box.
Are washable and will improve air flow. 42/43mm

Kit For Single Caliper Contains:

• 2 wiper seals
• 2 dust seals
• 1 caliper joint seal
• 1 sachet of red rubber grease

Kit Contains:

• 2 stainless steel pistons
• 2 wiper seals
• 2 dust seals
• 1 caliper joint seal
• 1 stainless steel bleed nipple
• 1 bleed nipple cover
• 2 copper washers
• 1 sachet red rubber grease

For Hoses requiring special fittings the banjos can only be supplied in silver.
Made to order, usually 24 hours to manufacture
This is a single line,
supplied with black heat shrink over the end of the hose

55mm between centre to centre

• 12 Volt and 6 Volt
• Lead acid, AGM and Gel batteries
• Quick mode change button on front face
• 1 Amp
• Battery Range 1.3-60Ah
• Cable Length 1m (To quick connect plug), 1.1m (Including clamps/eyelet cable)
• Trickle charger
• Quick release plug with cover
• Wall plug compact design
• Weight 0.58Kg

• 12 Volt and 6 Volt
• Lead acid, AGM, Gel and Lithium batteries
• Quick mode change button on front face
• 2 Amp
• Battery Range 1.3-60Ah
• Cable Length 1m (To quick connect plug), 1.1m (Including clamps/eyelet cable)
• Trickle charger
• Quick release plug with cover
• Wall plug compact design
• Weight 0.58Kg

Sold individually

Semi-Synthetic 2-Stroke engine oil for light motorcycles.
Low smoke.
For pre-mix and separate lubrication.

75W/85 - 10W30 - Rock Oil Lite Gear Oil is a unique,
lightweight, high performance synthetic enhanced lubricant
designed for use in sporting and competition transmissions
where the primary drive, clutch and gearbox components require
a high shock load resistance for optimum lubrication.
It is suitable for both wet and dry clutches.

JASO FC ISO-GD Grade. Low smoke and reduces exhaust clogging.
Suitable for modern engines.

White Lubricant.
Fully synthetic clear formula has absolute resistance against fling-off and is completely waterproof.
Compatible with o-rings, x-rings and z-rings.

Uno spray incolore resistente all'acqua e alla ruggine che lubrifica la catena della moto
anche ad alte velocità, riducendone gli schizzi
Particolarmente indicato per moto molto veloci,
Chain Lube Road riduce l'attrito e aumenta la durata della catena.

Motul Chain Lube Off Road è altamente raccomandato per l'uso fuoristrada.
Questo lubrificante per catene non contiene additivi appiccicosi
ed è adatto per sentieri e motocross.
Motul Chain Lube Off Road protegge le catene da grasso e accumulo di polvere.
Adatto a tutte le catene con o senza O-ring

Motul Chain Clean non utilizza cloro e dispone di un agente sgrassante estremamente potente
che rimuove i residui incrostati che aumentano l'usura della catena.
Se la catena è molto sporca, pulire con una spazzola non abrasiva e ripetere tutte le volte che è necessario.
Lasciare asciugare per 5 minuti, quindi lubrificare con Motul Chain Lube o Chain Paste.
Lubrificare sempre la catena con Motul Chain Clean prima di lubrificare.
Compatibile con tutti i tipi di catene: standard o O'ring, X'ring e Z'ring.

Automatic Chain Lubrication System for Motorcycles.
Eliminates chain cleaning, suits all types of chain including O ring.
Can be used for on and off road and gives between 2 to 7 times chain life.
Only suitable for motorcycles with a vacuum take-off point.
Motorcycles which don't have this feature will need to be fitted with the E-System instead.

This link is compatible with DID ZVM-X chains only.
For DID ZVM-2 chains please see our chain links section.